T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
29
Example
Specify the ten-gigabit port 1/1/2 as stack port when the Interface Card is
installed:
T3700G-28TQ(config)# switch stack-port interface ten-gigabitEthernet
1/1/2
show switch
Description
The show switch command is used to display the current stack’s information.
Syntax
show switch [ unitid | detail | neighbor | stack-ports ]
Parameter
unitid —— Specify the member number.
detail —— Display the detailed information of the stack, including stack member,
stack port and neighboring information.
neighbor —— Display the information of the stack neighbor.
stack-ports —— Display the information of the stack ports.
Command Mode
Privileged EXEC Mode and any Configuration Mode
Example
Display the detailed information of the current stack:
T3700G-28TQ(config)# show switch detail
To Next Page
Loading...
