TP-Link JetStream T3700G-28TQ - snmp-server community

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
221
show spanning-tree bridge
Description
The show spanning-tree bridge command is used to display the bridge
parameters.
Syntax
show spanning-tree bridge [forward-time | hello-time | hold-count | max-age |
max-hops | mode | priority | state]
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the bridge parameters:
T3700G-28TQ(config)#show spanning-tree bridge
show spanning-tree interface
Description
The show spanning-tree interface command is used to display the
spanning-tree information of all ports or a specified port.
Syntax
show spanning-tree interface [fastEthernet port | gigabitEthernet port |
ten-gigabitEthernet port] [edge | ext-cost | int-cost | mode | p2p | priority | role |
state | status]
Parameter
port —— The Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the spanning-tree information of all ports:
T3700G-28TQ(config)#show spanning-tree interface
Display the spanning-tree information of Gigabit Ethernet port 1/0/2:
T3700G-28TQ(config)#show spanning-tree interface gigabitEthernet 1/0/2
Display the spanning-tree mode information of Gigabit Ethernet port 1/0/2: