TP-Link JetStream T3700G-28TQ - passive-interface; ip rip receive version

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
328
show ip multicast
Description
The show ip multicast command is used to display the IP multicast
information.
Syntax
show ip multicast
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display ip multicast information:
T3700G-28TQ(config)# show ip multicast
show ip mroute
Description
The show ip mroute command is used to display the IP multicast routing table.
Syntax
show ip mroute [ [ group ip-addr ] [ source ip-addr ] | incoming-interface
interface-id ]
Parameter
group ip-addr —— Specify the multicast group IP address.
source ip-addr —— Specify the multicast source IP address.
incoming-interface interface-id —— Specify the incoming interface id of the
multicast group.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display all IP multicast routing entries:
T3700G-28TQ(config)# show ip mroute