TP-Link JetStream T3700G-28TQ - periodic

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
174
Example
Enable the multicast control function for Gigabit Ethernet port 1/0/5 and set the
bandwidth for receiving multicast packets as 256 kbps:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/5
T3700G-28TQ(config-if)#storm-control multicast 256
storm-control unicast
Description
The storm-control unicast command is used to enable the unicast control
function. To disable the unicast control function, please use no storm-control
unicast command. Unicast control function allows the switch to filter UL frame
in the network. If the transmission rate of the UL frames exceeds the set
bandwidth, the packets will be automatically discarded to avoid network
broadcast storm.
Syntax
storm-control unicast rate
no storm-control unicast
Parameter
rate —— Select the bandwidth for receiving UL-Frame on the port. The packet
traffic exceeding the bandwidth will be discarded. Range: 1 to 1000000 kbps for
the gigabit port, 1 to 10000000 kbps for the ten-gigabit port.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the unicast control function for Gigabit Ethernet port 1/0/5 and set the
bandwidth for receiving UL-Frame as 256 kbps:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/5
T3700G-28TQ(config-if)#storm-control unicast 256