TP-Link JetStream T3700G-28TQ - show qos interface; show qos cos-map

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
165
Chapter 23 Ethernet Configuration Commands
Ethernet Configuration Commands can be used to configure the Bandwidth Control, Negotiation
Mode and Storm Control for Ethernet ports.
interface fastEthernet
Description
The interface fastEthernet command is used to enter the interface
fastEthernet Configuration Mode and configure the corresponding Fast Ethernet
port.
Syntax
interface fastEthernet port
Parameter
port —— The Fast Ethernet port number.
Command Mode
Global Configuration Mode
Example
T3700G-28TQ doesn’t have any fastEthernet port.
interface range fastEthernet
Description
The interface range fastEthernet command is used to enter the interface
range fastEthernet Configuration Mode and configure multiple Fast Ethernet
ports at the same time.
Syntax
interface range fastEthernet port-list
Parameter
port-list —— The list of Fast Ethernet ports.