TP-Link JetStream T3700G-28TQ - description; ip route

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
260
no lldp transmit
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable Gigabit Ethernet port 1 to transmit LLDPDU:
T3700G-28TQ(config)# interface gigabitEthernet 1/0/1
T3700G-28TQ(config-if)#lldp transmit
lldp snmp-trap
Description
The lldp snmp-trap command is used to enable the port’s SNMP notification. If
enabled, the port will notify the trap event to network management system. To
disable the ports' SNMP notification, please use no lldp snmp-trap command.
Syntax
lldp snmp-trap
no lldp snmp-trap
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the SNMP notification for Gigabit Ethernet port 1/0/1:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/1
T3700G-28TQ(config-if)#lldp snmp-trap
lldp tlv-select
Description
The lldp tlv-select command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command.
By default, All TLVs are included in outgoing LLDPDU.