TP-Link JetStream T3700G-28TQ - show cable-diagnostics interface; show cpu-utilization

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
144
reboot
Description
The reboot command is used to reboot the switch. To avoid damage, please
don’t turn off the device while rebooting.
Syntax
reboot [ unitid ]
Parameter
unitid —— Specify the unit in the stack to reboot. If not specified, reboot all
members in the stack.
Command Mode
Privileged EXEC Mode
Example
Reboot all members in the stack:
T3700G-28TQ#reboot
copy running-config startup-config
Description
The copy running-config startup-config command is used to save the current
settings as the startup configuration file.
Syntax
copy running-config startup-config [ unit-id ]
Parameter
unit-id —— Specify the unit in the stack whose current settings would be saved
as the startup configuration file. If not specified, current settings of all the
members in the stack will be saved as their startup configuration file.
Command Mode
Privileged EXEC Mode
Example
Save unit 1’s current settings as the startup configuration file: