TP-Link JetStream T3700G-28TQ - show ip ospf request-list

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
364
Example
Prevent all the interfaces from sending OSPF packets in routing process 1:
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)# passive-interface default
no area
Description
The no area command is used to delete the specified area. Only areas
containing no networks can be deleted.
Syntax
no area area-id
Parameter
area-id ——The area ID, in the format of an IP address in dotted decimal
notation or decimal value ranging from 0 to 4294967295.
Command Mode
Router Configuration Mode
Example
Delete the OSPF area 1:
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)#no area 1
area description
Description
The area description command is used to configure the area name. To delete
the name of the specified area, please use the no area description command.
Syntax
area area-id description descript
no area area-id description