TP-Link JetStream T3700G-28TQ - qos queue mode

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
164
Parameter
unitid —— Specify the unit in the stack whose CPU utilization information will
be displayed. If not specified, the CPU utilization information of all the switches
in the stack will be displayed.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the CPU utilization information of all the switches in the stack:
T3700G-28TQ#show cpu-utilization
show memory-utilization
Description
The show memory-utilization command is used to display the system’s
memory utilization in the last 5 seconds/1minute/5minutes.
Syntax
show memory-utilization [ unitid ]
Parameter
unitid —— Specify the unit in the stack whose memory utilization information
will be displayed. If not specified, the memory utilization information of all the
switches in the stack will be displayed.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the memory utilization information of all the switches in the stack:
T3700G-28TQ#show memory-utilization