TP-Link JetStream T3700G-28TQ - lease; address hardware-address

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
269
Example
Enable NTDP function globally, and specify NTDP Hops as 5, NTDP Interval
Time as 30 minutes:
T3700G-28TQ(config)#cluster ntdp
T3700G-28TQ(config)#cluster ntdp timer interval-timer 30
T3700G-28TQ(config)#cluster ntdp hop 5
cluster explore
Description
The cluster explore command is used to collect the topology information
manually.
Syntax
cluster explore
Command Mode
Global Configuration Mode
Example
Collect the topology information manually:
T3700G-28TQ(config)#cluster explore
cluster
Description
The cluster command is used to configure cluster functions of a specified port.
Syntax
cluster [ndp { disable | enable }] [ntdp { disable | enable }]
Parameter
ndp —— Enable/ Disable NDP function for the port. By default, it is enabled.
ntdp —— Enable/ Disable NTDP function for the port. By default, it is enabled.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)