TP-Link JetStream T3700G-28TQ - Etherchannel Commands; channel-group

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
48
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the Gigabit Ethernet port 1/0/3 as the VPN UNI ports:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/3
T3700G-28TQ(config-if)#switchport dot1q-tunnel mode uni
show dot1q-tunnel
Description
The show dot1q-tunnel command is used to display the global configuration
information of the VLAN VPN.
Syntax
show dot1q-tunnel
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the global configuration information of the VLAN VPN:
T3700G-28TQ(config)#show dot1q-tunnel
show dot1q-tunnel mapping
Description
The show dot1q-tunnel mapping command is used to display the information
of VLAN Mapping entry.
Syntax
show dot1q-tunnel mapping