T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
119
show logging flash
Description
The show logging flash command is used to display the log information in the
log file according to the severity level in the specified unit or the whole stack.
Syntax
show logging flash [ level level ] [ unit unit-id]
Parameter
level —— Severity level. There are 8 severity levels marked with values 0-7.
The information of levels with priority not lower than the select level will display.
Display all the log information in the log file by default.
unit —— Specify the unit whose log information in the log file will be displayed.
The log information in the log files of the whole stack will be displayed by
default.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the log information with the level marked 0~3 in the log file of unit 2:
T3700G-28TQ(config)#show logging flash level 3 unit 2
To Next Page
Loading...
