TP-Link JetStream T3700G-28TQ - ip pim rp-candidate interface

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
305
Parameter
time —— Specify the max response time to the General Query message. The
default value is 10 seconds.
Command Mode
Interface Configuration Mode
Example
Configure the max response time to the General Query message as 5 seconds
on Interface VLAN 2:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip igmp query-max-response-time 5
ip igmp require-router-alert
Description
The ip igmp require-router-alert command is used to configure to check the
router-alert option of the IGMP messages on specified interface. To disable this
check function on this interface, please use no ip igmp require-router-alert
command.
Syntax
ip igmp require-router-alert
no ip igmp require-router-alert
Command Mode
Interface Configuration Mode
Example
Check the router-alert option of the IGMP messages on Interface VLAN 2:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip igmp require-router-alert
ip igmp robustness
Description
The ip igmp robustness used to configure the existing time of the non-querier
on specified interface. To restore to the default value on this interface, please
use no ip igmp robustness command.