T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
210
spanning-tree mst configuration
Description
The spanning-tree mst configuration command is used to access MST
Configuration Mode from Global Configuration Mode, as to configure the
VLAN-Instance mapping, region name and revision level. To return to the
default configuration of the corresponding Instance, please use no
spanning-tree mst configuration command.
Syntax
spanning-tree mst configuration
no spanning-tree mst configuration
Command Mode
Global Configuration Mode
Example
Enter into the MST Configuration Mode:
T3700G-28TQ(config)#spanning-tree mst configuration
instance
Description
The instance command is used to configure the VLAN-Instance mapping. To
remove the VLAN-instance mapping or disable the corresponding instance,
please use no instance command. When an instance is disabled, the related
mapping VLANs will be removed.
Syntax
instance instance-id vlan vlan-id
no instance instance-id [vlan vlan-id]
Parameters
instance-id —— Instance ID, ranging from 1 to 8.
vlan-id —— The VLAN ID selected to mapping with the corresponding
instance.
Command Mode
MST Configuration Mode
To Next Page
Loading...
