TP-Link JetStream T3700G-28TQ - VRRP Commands; vrrp vrid

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
315
T3700G-28TQ(config)# show ip igmp groups
show ip igmp groups interface
Description
The show ip igmp groups interface command is used to display the
information of all the dynamic multicast groups on the specified port.
Syntax
show ip igmp groups interface { fastEthernet | gigabitEthernet |
ten-gigabitEthernet } port [ detail ]
Parameter
fastEthernet | gigabitEthernet | ten-gigabitEthernet —— Specify the port type.
port —— Specify the port number.
detail —— The detailed information of the dynamic multicast groups.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the detailed information of the dynamic multicast groups on the
gigabitEthernet 1/0/1:
T3700G-28TQ(config)# show ip igmp groups interface gigabitEthernet 1/0/1
detail
show ip igmp groups interface vlan
Description
The show ip igmp groups interface vlan command is used to display the
information of all the dynamic multicast groups on the specified Interface.
Syntax
show ip igmp groups interface vlan vlan-id [ detail ]
Parameter
vlan-id —— Specify the interface VLAN ID.
detail —— The detailed information of the