Service Parts Disassembly 8-21
9. Using a PZ1 Posi bit, remove the 4 long screws securing the Printer Chassis to
the Feeder Assembly.
Caution
The washers on the long screws are not captive and can easily be dropped
into the chassis during removal or replacement. Be careful not to drop the
washers when removing and replacing the long screws.
Caution
Before lifting the Printer Chassis, ensure that harness P/J24 (gray), P/J210
(yellow), and P/J47 (yellow/blue) are positioned to slide through the slots in
the chassis bottom plate without catching.
ng
Lift the Printer Chassis off the Feeder Assembly by placing your hands into
the front and back cavity of the paper tray. The right and left sides of the
Printer Chassis are extremely sharp.
10. Lift the entire printer chassis off the Feeder Unit Assembly.
Replacement Notes
Caution
When replacing the Printer Chassis ensure that none of the wiring harnesses
between the Printer Chassis and Feeder Assembly are pinched.
To Next Page
Loading...
Need help?
General