Xerox PHASER 6250 - Electrical; AC Switch Harness Assembly (PL 12.1.11)

8-98 Phaser 6250 Color Laser Printer Service Manual
Electrical
AC Switch Harness Assembly (PL 12.1.11)
1. Remove the Top Main Cover (page 8-9).
2. Remove the Right Cover (page 8-11).
3. Remove the screw securing the ground wire to the LVPS (item #1).
4. Release the tabs securing the harness cable guide (item #2) to the AC Switch
bracket and move aside.
5. Disconnect P/J161 from the LVPS.
6. Press in on the tabs and push the AC connector to the rear, then to the side
through the notch in the chassis.
7. Press in on the tabs and remove the Harness Assembly AC Switch (item #3) from
the printer.
1
2
3
6250-231