Service Parts Disassembly 8-69
Housing Assembly Bias (PL 9.1.4)
Note
The Imaging Unit must be removed to prevent loss of the biasing buttons.
1. Remove the Imaging Unit and protect it from exposure to light.
2. Remove the Left Side Cover (page 8-11).
3. Disconnect all the wires routed along the left side (including the ground wire)
and remove them from the wire guides.
4. Remove the 5 screws securing the Housing Assembly Bias.
5. Remove the Housing Assembly Bias by pulling it straight out to avoid damaging
the spring contacts.
6250-204
To Next Page
Loading...
