8-60 Phaser 6250 Color Laser Printer Service Manual
Tray 1 Shaft (PL 6.1.28)
1. Remove the Chute Assembly Out (page 8-47).
2. Remove the spring from the Solenoid Stopper (item #2).
3. Release the tab securing the Solenoid Stopper to the shaft and remove.
4. Release the tab on the Tray 1 Gear (item #5) and remove the gear.
Note
Note the orientation of the springs for reassembly. A long eye hook attaches
to the shaft.
5. Remove the 2 springs (item #1 and #4) from the left and right sides of the shaft.
Note
In the following Step, do not lose the pins when moving the CAMs.
6. Release the tab securing each CAM in position and slide the CAMs (item #3) in.
7. Slide the shaft to the right and remove.
1
2
LEFT
FRONT
3
3
7
4
5
6
6250-191
To Next Page
Loading...
