Service Parts Disassembly 8-115
Harness Assembly Tray 3
1. Disconnect P/J82 (gray) from the HCF Circuit Board
2. Remove the Harness Assembly Tray 3.
Harness Assembly Tray 4
1. Disconnect P/J83 (blue) from the Power Feeder Circuit Board and remove the
Harness Assembly Tray 4.
Harness Assembly Feeder Plug
Note
The wide slot in the middle of the plug faces outward. The tabs on the
bottom of J810 can be easily damaged during the removal process.
1. Disconnect P/J81 (yellow) from the Power Feeder Circuit Board.
2. Remove J810 by lifting out of the hole in the top of the HCF frame.
3. Lift the entire Harness Assembly Feeder Plug through the hole in the top of the
HCF frame.
To Next Page
Loading...
