8-134 Phaser 6250 Color Laser Printer Service Manual
Harness Assembly Tray 3
1. Disconnect P/J82 (gray) from the STF Circuit Board
2. Remove the Harness Assembly Tray 3.
Harness Assembly Feeder Plug
Note
The wide slot in the middle of the plug faces outward. The tabs on the
bottom of J810 can be easily damaged during the removal process.
1. Disconnect P/J81 (yellow) from the Power Feeder Circuit Board.
2. Remove J810 by lifting out of the hole in the top of the STF frame.
3. Lift the entire Harness Assembly Feeder Plug through the hole in the top of the
STF frame.
To Next Page
Loading...
Need help?
General