7-6
THROTTLE BODY
Removing the throttle body
Order Job/Parts to remove Q’ty Remarks
Windshield/Front cover/Windshield inner panel/
Meter assembly/Rearview mirror/Bottom side
cowling/Side panel/Front cowling assembly/Leg
shield assembly
Refer to “GENERAL CHASSIS (1)” on
page 4-1.
Center cover/Fuel tank cover assembly/Side
cover/Rear side cowling assembly/Footboard
Refer to “GENERAL CHASSIS (2)” on
page 4-11.
Fuel tank Refer to “FUEL TANK” on page 7-1.
Air filter case
Disconnect.
Refer to “THROTTLE BODY” on page 7-5.
Canister purge hose (hose joint to canister)
Disconnect.
Refer to “FUEL TANK” on page 7-1.
1 Throttle servo motor coupler 1 Disconnect.
2 Throttle position sensor coupler 1 Disconnect.
3 Intake air pressure sensor coupler 1 Disconnect.
4 Injector coupler 2 Disconnect.
5 Throttle body joint clamp screw 2 Loosen.
6 Intake air pressure sensor hose 1
7 Throttle body assembly 1
8 Intake air pressure sensor 1
1
2
5
5
6
8
7
(3)
3 4
New
New
New
New
New
New
10 N・m (1.0 kgf・m, 7.4 lb・ft)
3.8 N・m (0.38 kgf・m, 2.8 lb・ft)
3.5 N・m (0.35 kgf・m, 2.6 lb・ft)
3.0 N・m (0.30 kgf・m, 2.2 lb・ft)
To Next Page