4-18
182582-1CD
182582-1CD
4 Connection
4.3 Connection Methods
MH900, DX200 Controller
4. Route the system external signal cables for the external emergency
stop, etc. drawn in step 2, to the right side of the controller from the
bottom side of the controller as shown by the red line in the figure
below. And then, connect the cables to the machine safety terminal
block circuit board (JANCD-YFC22-E). For details of the connection,
refer to "Wiring Procedure of the Terminal Block" in section 14.6
“Machine Safety Terminal Block Circuit Board (JANCD-YFC22-E)” on
page 14-14
Fig. 4-20: Routing System External Signal Cable .
Machine safety terminal
block circuit board
(JANCD-YFC22-E)
from the bottom
of the controller.
To Next Page
Loading...
