YASKAWA V1000 Series Installation & Start-Up Manual

B.2 Parameter Table
426 YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
E2-01
(E4-01)
Motor Rated Current A 7
E2-02
(E4-02)
Motor Rated Slip Hz 2.7
E2-03
(E4-03)
Motor No-Load Current A 2.3
E2-05
(E4-05)
Motor Resistance Between Lines Ω 3.333
E2-06
(E4-06)
Motor Leakage Inductance % 19.3
E2-10 Torque Compensation Motor Loss W 130
L2-02 Momentary Power Loss Ride-Thru Time sec. 0.5
L2-03 Minimum Baseblock Time sec. 0.6
L2-04 Voltage Restoration Time sec. 0.3
L3-24 Inertia Motor Acceleration Time sec. 0.154
L8-02 OH Pre-Alarm Level °C 100
L8-04 OH Detection Level °C110
L8-09 Ground Protection Selection – 0
L2-05 UV Detection Level C 380 380
C6-21
Two Phase/Three Phase Switching Voltage
Level (%)
%30 30
C6-22
Two Phase/Three Phase Switching
Frequency Level (Hz)
Hz 18 18
No. Name Units Factory Default Value

YASKAWA V1000 Series Specifications

General

Model	V1000 Series
Series	V1000
Output Frequency	0.1 to 400 Hz
Overload Capacity	150% for 60 seconds
Type	AC Drive
Control Method	V/f Control
Input Voltage	200-240V, 380-480V
Output Voltage	0 to Input Voltage
Power Range	0.1 to 18.5 kW
Horsepower	0.2 to 25 HP
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault
Communication Interfaces	Modbus RTU
Enclosure	IP20
Ambient Temperature	-10 to +50°C
Storage Temperature	-20 to +60°C
Humidity	5 to 95% RH (non-condensing)
Cooling Method	Fan Cooled