Agilent Technologies 5DX Service Guide

1-6 Introduction and Overview
What is the 5DX Automated X-ray Inspection System? 5DX Series 3
The 5DX System Process
Figure 1-3 is a flow chart illustrating the process that a panel goes through within
the 5DX System.
Figure 1-3: Test Process Flow Chart
The PCA is loaded into the 5DX. For the 5DX to correctly test the solder joints,
the PCA has to be aligned. A surface map is made to compensate for variations in
the manufacturing process. The solder joints are measured and these
measurements are analyzed by the algorithms to determine if they pass or fail. The
algorithm thresholds, set up by the user will determine the pass or fail criteria. The
PCA is then unloaded from the 5DX.
)LUVWWLPH$OLJQ
6XUIDFH0DSDQG
&KHFN&$'
$XWR$OLJQ
6XUIDFH0DS
8QORDG
(MHFWWHVWHGSDQHOWR
FRQYH\RUV\VWHP
6HOHFW2XWSXWDQG
)RUPDW
6HOHFWDQG5XQ7HVW
/RDGQH[WSDQHO
6HOHFWDQG7XQH
$OJRULWKPV
/RDG

Agilent Technologies 5DX Specifications

General

Brand	Agilent Technologies
Model	5DX
Category	Medical Equipment
Language	English