Agilent 5DX Service Guide 2-3
5DX Series 3 Warnings
Warnings
This machine is classified as a Class I Laser Product containing a Class IIIB Laser
Subsystem, with an output of 780 nM <5 mW.
Use only QUALIFIED personnel to service this equipment.
WA R N I NG This product produces X-rays. Do not attempt to open any part of the
product. Do not operate this product or turn on the X-ray source unless all
shielding is in place. Operation without shielding in place can result in
exposure to X-rays. Exposure to X-rays can cause serious bodily injury.
Refer servicing to service-trained personnel.
WA R N I NG This product produces High Voltage. Do not attempt to open any part of the
product. High Voltage can cause electrical shock resulting in serious bodily
injury. Refer servicing to service-trained personnel.
WA R N I NG This product produces Laser Light Emissions. Do not attempt to open any
part of the product. Laser Light Emissions can cause serious eye injury.
Refer servicing to service-trained personnel
WA R N I NG Do not, for ANY reason, attempt to defeat the built-in safety interlocks.
Operation without the Safety Interlock Subsystem functional can result in
exposure to X-rays, high voltage or laser light emissions. Exposure to X-
rays can cause serious bodily injury. Contact with high voltage can cause
electrical shock resulting in serious bodily injury. Exposure to laser light
emissions can cause serious eye injury
WA R N I NG Always DISCHARGE all high voltage connections prior to servicing
WA R N I NG There is a service key that can be used to override motion control interlocks
for diagnostic purposes. NEVER place any body part (hand, arm, etc.) or
any other object inside the 5DX when this override is enabled.
To Next Page
Loading...
Need help?
General
