Example 5: Using Two Sensors Measurement Examples
7-14 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
When using the Sensor Menu options to change settings such as Mode, Calibration Factor,
Averaging etc. make sure that you are effecting the changes on the correct sensor. Change
from sensor A to sensor B by using the [SENSOR] soft key.
Additional soft keys are included in the Cal/Zero Menu options — [Sensor A] and [Sensor B].
Select as appropriate.
After a Preset, channel 1 is allocated to sensor A and channel 2 is inactive.
To Next Page
Loading...
