Anritsu ML2437A - BP (Set Single Sensor B Display)

GPIB Operation HP438A Emulation Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-123
BP (Set single sensor B display)
BR (Set display B / A)
CL (Cal Adjust)
CS (Clear all status bytes)
DA (Display All)
DD (Display disable)
Syntax: BP
Remarks: Display Input B readings.
Syntax: BR
Remarks: Display the Input B reading divided by the Input A reading.
Syntax: CL<val><terminator>
val: 50.0 to 120.0
terminator: %, PCT, EN
Remarks: Same as the ML24XXA (native) CFADJ command. Sets a calibration
factor to be used when performing a 0 dBm calibration.
Examples: CL98.5EN
CL98.5%
CL98.5PCT
Syntax: CS
Remarks: Same as the *CLS command. Resets all of the GPIB status registers and
clears the input queue.
Syntax: DA
Remarks: Turns on all the segments of the display to verify proper operation. The
display is returned to normal when another command is sent.
Syntax: DD
Remarks: Turns the display off to allow faster measurements to be taken.
Related
commands:
DE