Anritsu ML2437A - MODPH (Autodial Phone Number); MODPWR (Autodial Enable for Power On); MODRED (Redial Count)

GPIB Operation ML24xxA Native Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-55
MODPH (Autodial phone number)
MODPWR (Autodial enable for power on)
MODRED (Redial count)
Syntax: MODPH <number_text>
number text: the number to be dialed
Remarks: Enter the phone number to be dialed when autodialing is enabled.
Reads in a string of up to 40 ASCII characters or the end of the message.
When the number is being dialed, a dot (.) will be interpreted as a
2-second delay in the dialing sequence; a minus sign (–) will be
interpreted as wait for another dialing tone. See Section 5-10 for more
information on modem operation.
Query: MODPH?
Returned String: MODPH <number text>
Syntax: MODPWR <state>
value: TRUE or FALSE
Remarks: When set to TRUE, produces an SRQ and autodials the phone number
(set with MODPH) when the ML243xA is powered on. See Section 5-10
for more information on modem operation.
Query: MODPWR?
Returned String: MODPWR <true> or <false>
Syntax: MODRED <count>
count: 0 to 10
Remarks: Sets the number of retrys after a failure to connect. The delay between
retrys is set using MODDEL. See Section 5-10 for more information on
modem operation.
Query: MODRED?
Returned String: MODRED <count>