ML24XXA Quick Reference
ML2437A/38A OM/PM PN: 10585-00001 Rev. P C-3
Display Functional Group Commands
GPIB 488.2 Functional Group Commands
GPIB Setup Functional Group Commands
Table C-5. Display Functional Group Commands
Command Function
DCONT(?) Set display Contrast
DCONTD Set display contrast down by one
DCONTU Set display contrast up by one
DISP(?) Display ON or OFF
DPEAK(?) Peak meter display
Table C-6. GPIB 488.2 Functional Group Commands
Command Function
*CLS Clear GPIB status bytes
*ESE Event Status Byte enable
*ESE? Return Event status register enable mask
*ESR? Event status register request
*IDN? Request device identification
*OPC Operations complete
*OPC? Operations complete Output '1'
*RST Reset device
*SRE Setup service request enable register
*SRE? Return Service Request enable register
*STB? Return status byte register
*TRG Perform a trigger 'GET' command
*TST? Self Test
OI Request device identification
Table C-7. GPIB Setup Functional Group Commands
Command Function
ADDR(?) Change GPIB address
CONT Continue
EMUL GPIB emulation mode
FAST(?) Operate in non-488.2 compliant mode
START Initial startup self test command
To Next Page
Loading...
