ML24xxA Native Commands GPIB Operation
8-32 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
DCONT (Set Display Contrast)
DCONTD (Set display contrast down by one)
DCONTU (Set display contrast up by one)
DISP (Display On or OFF)
Syntax: DCONT <val>
val: 1 to 10
Remarks: One is the lightest setting, ten the darkest. The default is five.
Query: DCONT?
Returned String: DCONT <val>
Syntax: DCONTD
Remarks: Make the display lighter by lowering the contrast by one level.
Syntax: DCONTU
Remarks: Make the display darker by increasing the contrast by one level.
Syntax: DISP <state>
state: ON or OFF
Remarks: When using GPIB measurement, speed can be increased by not
updating the display. This command turns off the display and writes
REMOTE across the screen. If the LOCAL soft key is pressed, the
system reverts to DISP ON. The restrictions of this mode are:
1. Min max values read via the GPIB are not updated.
2. Relative operation is ignored so that the normal value is given.
3. DISP will not operate when sent via RS232.
Query: DISP?
Returned String: DISP <state>
To Next Page
Loading...
