GPIB Operation HP437B Emulation Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-119
SN (Cal table identity update)
ST (Store setup)
SV (Save cal factor table)
TR0 (Trigger hold mode)
Syntax: SN<val>
val: up to seven characters
Remarks: Since the ML243xA stores the cal factor table information in the sensor,
this data must be saved to the sensor by using the ‘EX’ command or an
additional command ‘SV’, or the data could be lost. The saving of the cal
factor table data to the sensor can be done at the end of all updates to a
particular table.
Syntax: ST<val>EN
val: 1 to 10
Remarks: Stores the present configuration to the selected register.
Example: To store the current instrument configuration in register 2:
ST2EN
Related
commands:
RC
Syntax: SV
Remarks: Since the ML243xA stores the cal factor tables in the sensors, this
command forces the edits to a cal factor table to be saved to the sensor.
The operation can take a couple of seconds to complete.
Syntax: TR0
Remarks: Sets both channels to trigger hold mode. It does not trigger until it
receives a TR1 or TR2 or GET (group executive trigger), *TRG or TR3
command. If it receives a TR3 command it reverts back to the trigger
mode it was in before the TR0 command was sent. If the REM line is
low, this command has no effect.
Related
commands:
TR1, TR2, TR3, *TRG, Group Execute Trigger (GET), GT0, GT1, GT2
To Next Page
Loading...
