Anritsu ML2437A - START (Initial Startup Self Test Command)

ML24xxA Native Commands GPIB Operation
8-72 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
START (Initial startup self test command)
Syntax: START
Remarks: This is useful for ATE control. After the system has been given time to
start up, this command can be used to find out what state the system is
in. If the self test has failed, 'CONT' can be used to get the system
running. This is an initial startup self test status command and will
return one of the following:
0 - Passed self test and running.
1 - Startup self test running.
–1 - Start up self test FAILED.
In this stage of the startup process, all commands except STERR,
START, CONT and GPIB 488.2 event and status commands will
produce a GPIB execution error. STERR will return the selftest result
string.
Related
commands:
STERR, CONT