HP436A Emulation Commands GPIB Operation
8-100 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
Z (Zero sensor)
Output Format
The output data format for the HP436A emulation mode is shown below.
Syntax: Z
Remarks: Zero out the noise from the sensor. When zeroing the ML2430 in HP436
emulation mode, the 'Z1T' sequence followed by the '9+DI' described in
the HP436 manual must be followed.
Figure 8-9. HP 436A Output Data Format
Range
Decimal
Point
Measured
Value
(4 digits)
Status
Mode
Sign of
Measured Value
space (+) or “-”
Exponent
(2 digits)
- EXPONENT
Measured
Value
Multiplier 10
Character
Number
E
-
10
11
CR LF
0
12
3
4
5
67
To Next Page
Loading...
