ML24xxA Native Commands GPIB Operation
8-40 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
GPRST (Reset min/max graph)
GRAUTO (Auto scaling)
GRAVG (Average between profile cursors)
GRCP (Connect points on profile)
Syntax: GPRST
Remarks: When profile DATA HOLD mode is set to Min/Max points, this
command is used to reset the min/max values for each data point.
Related
commands:
GRPIX
Syntax: GRAUTO
Remarks: Auto scale for all graphic modes (Profile, Source Sweep and Power vs.
Time). This command auto scales the y axis only based on the currently
displayed data.
Syntax: GRAVG <state>
state: ON or OFF
Remarks: Turns on or off averaging between cursors. The data returned by the
GRDRQ command includes the average of all data points between the
cursors if GRAVG is turned ON.
Related
commands:
GRDRQ
Query: GRAVG?
Returned String: GRAVG <state>
Syntax: GRCP <state>
state: ON or OFF
Remarks: When set to ON, creates a line graph by connecting the profile data
points together. The default is ON.
Query: GRCP?
Returned String: GRCP <state>
To Next Page
Loading...
