Anritsu ML2437A - System Defaults

System Defaults
ML2437A/38A OM/PM PN: 10585-00001 Rev. P B-3
B-2 System Defaults
The following default parameters are loaded whenever preset is selected from the front panel
or through GPIB.
SENSOR - setup
settle % per reading 0.10 %
measurement mode default
range hold auto
SENSOR - cal factor
Source Frequency
source ( HP437B & HP438A ) manual
source = frequency
input signal frequency 50 MHz
source = manual
cal factor 100 %
cal adjust 100 %
input signal frequency 50 MHz
source = volts/GHz
start freq 10 MHz
stop freq 20 GHz
start voltage 0 volts
stop voltage 10 volts
units percent
SENSOR - averaging
SYSTEM - setup = readout or Power vs. Time
Mode auto
mode ( HP437B & HP438A ) auto
mode = moving
mode = repeat
averaging number 64
auto low level averaging low
SYSTEM - setup = profile