Anritsu ML2437A - ESE? (Return Event Status Register Enable Mask); ESR? (Event Status Register Request); RST (Reset Device); SRE (Setup Service Request Enable Register)

GPIB Operation HP437B Emulation Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-105
*ESE? (Return Event status register enable mask)
*ESR? (Event status register request)
*RST (Reset Device)
*SRE (Setup service request enable register)
*SRE? (Return Service Request Enable register)
Syntax: *ESE?
Remarks: Returned format: <unsigned character>
When converted to an 8-bit binary number, this byte yields the bit
settings of the register.
Syntax: *ESR?
Remarks: Return the value of the standard event status register. Afterwards the
event status register are cleared. The returned format is: <unsigned
character>. When converted to a 8-bit binary number, this byte yields
the bit settings of the register.
Syntax: *RST
Remarks: Resets the ML243xA to the default configuration (see Appendix A,
Section A-3, or see the HP manual when in HP437B emulation mode).
Offset tables are not cleared. The GPIB ADDRess and EMULation
settings are not changed, and the input queue, output queue, and status
registers on the GPIB are not cleared. This command produces the same
result as the front panel key sequence System > Setup > PRESET >
RESET.
Syntax: *SRE <val>
val: 8-bit mask
Remarks: Sets the Service request enable register bits.
Syntax: *SRE?
Remarks: Returns the Service Request Enable register.