HP437B Emulation Commands GPIB Operation
8-108 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
DC (Duty Cycle state)
DD (Display disable)
DE (Display enable)
DF (Display disable)
DR (Set GPIB address)
Syntax: DC<state>
state:
0 = OFF
1 = ON
Remarks: Turns on or off application of the duty cycle to the sensor data.
Syntax: DD
Remarks: Turns the display off to allow faster measurements to be taken.
Related
commands:
DE, DF
Syntax: DE
Remarks: Return the display to normal operation after the display has been set in
DD mode.
Related
commands:
DD, DF
Syntax: DF
Remarks: Turns the display off to allow faster measurements to be taken.
Related
commands:
DD, DE
Syntax: DR<val><terminator>
val:
1 to 30
terminator:
EN
Remarks: Changes the device address. The power meter default address is 13.
To Next Page
Loading...
