Front Panel Operation System Menu
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 5-31
PEAKMETER [DPEAK]
Turns on the peakmeter display for Sensor A, Sensor B, or both Sensors A and B. The
peakmeter display will eclipse any trigger icons. The peak meter display range covers
12 dB. When above the displayed maximum or below the displayed minimum, the
range is switched by 10 dB in the appropriate direction.
Note that in the event that the channel is displaying an alternative measurement (for
example, external volts from the rear panel BNC) the peak meter will continue to
represent the Sensor A and/or B data. This is useful for monitoring an external voltage
on the meter, while peaking up a response being monitored by a sensor, such as RF
output.
FREQ [FROFF]
Turns FREQuency offset display ON or OFF. When ON, a continuous indication of the
frequency (used for Cal Factor) is displayed in small text at the top of the display along
with any sensor offset (if applied).
TEXT [TEXT, TEXTS]
GPIB user TEXT display ON or OFF. When ON, a user-defined text string can be
displayed at the top of the display area. The text string can only be defined over the
GPIB.
Sound
Controls system sounds.
KEY [KEYCK]
Turns the audible key click on or off.
EDIT [ENTERR]
Turns the audible edit error tone on or off.
LIMIT 1 [FBEEP]
Limit Fail beep on channel 1 on or off.
LIMIT 2 [FBEEP]
Limit Fail beep on channel 2 on or off.
CURSOR
CURSOR out of screen beep. If a cursor is moved into an illegal space, such as the edge
of the screen or the end of valid data, a warning beep is sounded.
To Next Page
Loading...
