Anritsu ML2437A - CUR (Cursor in Power Vs. Time and Source Sweep Modes); CURLK (Link Cursors in All Graphic Modes)

GPIB Operation ML24xxA Native Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-29
CUR (Cursor in Power vs. Time and Source Sweep modes)
CURLK (Link cursors in all graphic modes)
Syntax: CUR <cursor>,<fval>
cursor: 1 or 2
fval: 0.0 to 1440 min (24 h) in Power vs. Time mode
In Source Sweep mode, Power sweep: -120.0 dB to 30.0 dB
In Source Sweep mode, Frequency sweep : 10.0 kHz to 122.0 GHz
Remarks: In Power vs. Time mode, the fval parameter is in minutes. In Source
Sweep mode, the fval parameter is in dB or Hz for a power sweep or
frequency sweep respectively.
Examples:
Power vs. Time:
Set cursor 1 to 30 s: CUR 1,0.5
Set cursor 2 to 12.5 h: CUR 2,750
Source sweep:
Power Sweep, set cursor 1 to 11.5 dB: CUR 1,11.5
Frequency Sweep, set cursor 2 to 15.6 GHz: CUR 2,15.6GHZ
Related
commands:
GRDDT, SRCSPFRQ, SRCSTFRQ, SRCSTPWR, SRCSPPWR
Syntax: CURLK <state>
state: ON, OFF
Remarks: Links the two cursors together on the graph. When either cursor moves
left or right, the other cursor follows. Subsequent changes to delay will
move both cursors.
Query: CURLK?
Returned String: CURLK <state>