Anritsu ML2437A - ODT (Output the Current Calibration Factor, Offset, and Reference Level)8-91; OFF (Set Sensor Offset Value); OI? (Request Identity)

GPIB Operation ML4803A Emulation Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-91
ODT (Output the current calibration factor, offset, and reference level)
OFF (Set sensor offset value)
OI? (Request identity)
Syntax: ODT
Remarks: These are output as three separate messages in the output buffer, as
shown below:
CAL factor: 18 ASCII characters + <CR><LF>
OFFSET value: 18 ASCII characters + <CR><LF>
REFERENCE level: 19 ASCII characters + <CR><LF>
Note: When the ODT, OMR, and OPW data output commands are received
simultaneously, only the command which is received last is valid.
Figure 8-4. ODT Data Output Format
Syntax: OFF<value>
value: Offset value to add to the sensor reading.
Syntax: OI?
Remarks: Response: <ML4803>
1 5 10 15
CAL
dB
<CR><LF>
OFFSET
dB
<CR><LF>
REFERENCE
5 character data
dBm <CR><LF>
±
±
.
.
.