Anritsu ML2437A - FH (Average Hold); FM (Set Average Value); FR (Frequency of the Input Signal)

GPIB Operation HP437B Emulation Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-111
FH (average hold)
FM (Set average value)
FR (Frequency of the input signal)
Syntax: FH
Remarks: Hold filter sets the filter mode to Manual from Auto, but retains the
auto filter setting. This function is the same as the AVGM command.
Related
commands:
FM, FH, FA
Syntax: FM<val>EN
val: 1 to 512
Remarks: Sets the filter length for the averaging of sensor data. For HP437B
emulation, the command accepts 1 to 512 in 2-to-the-power steps. For
example, 1, 2, 4, 8, 16,...256, 512.
Related
commands:
FH, FA
Syntax: FR<val><units>
val:
units:
GZ (GHz)
MZ (MHz)
KZ (kHz)
HZ (Hz)
EN (Hz)
Remarks: Sets the frequency of the input signal so that the correct cal factor is
used.
Example: To set the frequency of the input signal to 300 MHz:
FR300MZ