Anritsu ML2437A - HP438 A Commands

HP-IB Support
ML2437A/38A OM/PM PN: 10585-00001 Rev. P C-21
HP438A Commands
Table C-19. HP438A Commands
Mnemonic Action Supported? Restrictions
AD Config to A-B Yes None
AE Select sensor A Yes None
AP Config to A Yes None
AR Config A/B Yes None
BD Config to B-A Yes None
BE Select sensor B Yes None
BP Config to B Yes None
BR Config to B/A Yes None
CL CAL 0 dBm Yes None
CS Clear status Yes None
DA Set all screen pixels Yes None
DD Disable display Yes DISP OFF restrictions:
Screen and min/max
not updated, Relative
not active.
DE Display enable Yes DISP ON. None.
DO Display to offset No Not supported
EN Enter msg terminator Yes None
FA Auto average Yes None
FH Average hold Yes None
FM Manual average Yes None
GT0 Ignore GET Yes None
GT1 TR1 on GET Yes None
GT2 TR2 on GET Yes None
KB Set cal factor Yes None
LG Units to dBm Yes None
LH Set high limit Yes On channel not
sensor.
LL Set low limit Yes On channel not sensor
LM0 Limit check off Yes Both high and low off
as HP437B
LM1 Limit check on Yes Both high and low on
as HP437B
LN Units to Watts Yes None
LP1 Learn mode1 No Not supported