HP-IB Support
C-20 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
RL0 Relative mode off Yes None
RL1 New relative value Yes None
RL2 Use old relative value Yes None
RM Set sensor range Yes ML243xA ranges
*RST Reset Yes None
RT Right arrow No Not supported
RV Read SRE Yes None
SE Select data table Yes None
SM Status output Yes As much as has
meaning for
ML243xA. Set to 0 if
not used
SN0-SN9 Serial number Yes None
SP Special No Not supported
*SRE Set SRQ enables Yes None
*SRE? Read SRQ enables Yes None
ST Store setup Yes Limited to 10 stores
*STB? Read status byte Yes None
TR0 GPIB trigger hold Yes None
TR1 Immediate trigger Yes None
TR2 Settled trigger Yes None
TR3 Trigger hold off Yes None
*TST? Selftest Yes Always returns 0
UP Up arrow No Not supported
@1 Status mask Yes None
@2 Learn mode 2 No Not supported
% Terminator Yes None
Table C-18. HP437B Emulation Mode Commands
Mnemonic Action Supported? Restrictions
To Next Page
Loading...
