HP-IB Support
ML2437A/38A OM/PM PN: 10585-00001 Rev. P C-19
GT2 TR2 on GET Yes None
GZ Terminator Yes None
HZ Terminator Yes None
ID Return ID string Yes None
IDN? Return ID string Yes None
KB Set cal factor Yes None
KZ Terminator Yes None
LG Units to dBm Yes None
LH Set high limit Yes On channel not
sensor.
LL Set low limit Yes On channel not sensor
LM0 Limit check off Yes Both high and low off
as HP437B
LM1 Limit check on Yes Both high and low on
as HP437B
LN Units to Watts Yes None
LP Learn mode 1 No Not supported
LT Left arrow No Not supported
MZ Terminator Yes None
OC0 RF calibrator off Yes None
OC1 RF calibrator on Yes None
OD Output display text Yes Supports reading
output and Cal factor
table output only.
(F=Factory table.)
OF0 Offset off Yes None
OF1 Offset on Yes None
OS Set offset value Yes OSDOEN not
supported
PCT Terminator Yes None
PR Preset Yes None
RA Auto range Yes None
RC Recall setup Yes Limited to 10 stores
RE Resolution Yes Set screen decimal
places
RF0-RF9 Sensor cal factors Yes None
RH Range hold Yes None
Table C-18. HP437B Emulation Mode Commands
Mnemonic Action Supported? Restrictions
To Next Page
Loading...
