GPIB Operation HP437B Emulation Commands
ML2437A/38A OM/PM PN: 10585-00001 Rev. P 8-109
DY (Duty Cycle)
EMUL (GPIB emulation mode)
Syntax: DY<val><terminator>
val: duty cycle value in percent
terminator: %, PCT, or EN
Remarks: Sets the duty cycle to be applied to the input signal.
Syntax: EMUL <mode>
mode:
ML24XX (Anritsu ML243xA native mode)
HP436A (Hewlett-Packard)
HP437B (Hewlett-Packard)
HP438A (Hewlett-Packard)
ML4803 (Anritsu ML4803A Series)
Remarks: Set the GPIB emulation to emulate other types of power meters. This
command is available in any emulation mode, and resets the whole
GPIB interface when the emulation mode is changed.
When selecting GPIB emulation modes, the instrument configures itself
to the preset conditions of the instrument to be emulated. For example,
when selecting HP438A emulation, the front panel menus pass through
the presets for the HP437B (which presets sensor A to dBm) then selects
HP438A emulation (which presets sensor A to Watts).
To Next Page
Loading...
