Anritsu ML2437A - TRGDLY (Trigger Sample Delay); TRGGW (Set Trigger Gate Width)

ML24xxA Native Commands GPIB Operation
8-80 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
TRGDLY (Trigger sample delay)
TRGGW (Set trigger gate width)
Syntax: TRGDLY <c>, <val>[units]
c: 1, 2 or 1&2
val: 0.0 to 1.0 s
Remarks: The time the system waits after a trigger event has happened
before taking measurements when in READOUT or Power vs. Time
mode.
Select channel 1, 2 or 1&2. Selecting 1&2 allows both channels to trigger
together on the same conditions without having to set up two sets of
trigger data.
Query: TRGDLY? <c>
Returned String:
TRGDLY <c>,<val>
The TRG type commands return the trigger state of the selected channel
if the channel is ON. This depends on the settings of the “link triggers”
flag and the current mode of the sensor on the selected channel. If the
channel is OFF, the stored trigger state of the channel is returned.
Syntax: TRGGW <c>,<val>[units]
c: 1, 2 or 1&2
val: 100 ns to 7.0 s
Remarks: The length of time the system uses to collect data when in READOUT or
Power vs. Time mode. The default value is 20 ms.
Select channel 1, 2 or 1&2. Selecting 1&2 allows both channels to trigger
together on the same conditions without having to set up two sets of
trigger data.
Query: TRGGW? <c>
Returned String: TRGGW <c>,<val>
The TRG type commands return the trigger state of the selected channel
if the channel is ON. This depends on the settings of the “link triggers”
flag and the current mode of the sensor on the selected channel. If the
channel is OFF, the stored trigger state of the channel is returned.