ML4803A Quick Reference
C-12 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
C-2 ML4803A Quick Reference
The following tables reference ML4803A emulation mode commands.
ML4803A Emulation Mode Commands
Table C-14. ML4803A Emulation Mode Commands
Command Function
AVE Sensor averaging setting
CAL Set the user cal factor value
CCA Clear the user cal factor to zero
CDJ Perform a Cal 0 dBm
COF Clear the offset value to zero
COS Turn ON the 50 MHz, 0 dBm RF calibrator
output
CRF Clear the reference value to zero
CST Turn OFF the 50 MHz, 0 dBm RF calibrator
output
DBM Sets the display channel units to dBm
DBR Set the display channel units to dB and takes
the relative value
EMUL GPIB emulation mode
MCA Set the cal factor value at the specified
memory location in dBm
MCC Clears the cal factor value at the specified
memory location
MCO Clears the offset value at the specified memory
location
MCQ Clears the frequency value at the specified
memory location
MCR Clears the reference value at the specified
memory location
MCT Clears all values at the specified memory
location
MDI Disable memory store setting and use
MEN Enable setting of the memory stores and apply
the last memory store configured
MFG Set the frequency value at the specified
memory location in GHz
MFM Set the frequency value at the specified
memory location in MHz
To Next Page
Loading...
