Anritsu ML2437A - SYSLNM (Saved Set Naming); SYSRD (Output the Saved Setup over the GPIB)

ML24xxA Native Commands GPIB Operation
8-76 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
SYSLNM (Saved set naming)
SYSRD (Output the saved setup over the GPIB)
Syntax: SYSLNM <store number>,<text>
store number: 1 to 10
text: text string
Remarks: This command allows the saved setups to have text associated with
them rather than just the ‘USED’ and ‘NOT USED’ text.
Query: SYSLNM? <store number>
Returned String:
SYSLNM <store number>,<store name>
If a store number of 0 is used, then all the store titles will be output in
the form:
SYSLNM 1,<store 1 name>,2,<store 2 name>, … ,10,<store 10 name>
Syntax: SYSRD <store number>
store number: 0 (current setup) or 1 to 10 saved stores
Remarks: Requests that the saved stored setup is output over the GPIB. This is a
BINARY output that allows the stored setup to be programmed into
other ML243xA power meters and stores via the SYSLD command. If a
request for a store number that has not had a setup stored into it is
made, an execution error event will be set in the Event Status Register
(ESR).
The output is in the form:
SYSRD<ws><#><num_digits><number num_digits long>, <binary
data>
<num_digits> = Number of following digits giving the number of bytes of
binary data.
<number num_digits long> = A number num_digits long giving the
number of bytes of binary data.
<binary data> = Saved setup.
Related
commands:
SYSLD