ML24xxA Native Commands GPIB Operation
8-50 PN: 10585-00001 Rev. P ML2437A/38A OM/PM
HLIMS (Turn on/off High limits)
HOLD (Graph hold)
IBBLP (Blanking active TTL level)
Syntax: HLIMS <c>,<state>
c: 1 or 2
state: ON or OFF
Remarks: The HLIMS command turns the limits on and off.
Related
commands:
HLIM
Query: HLIMS? <c>
Returned String: HLIMS <c>,<state>
Syntax: HOLD <state>
state: ON or OFF
Remarks: This command holds the present graph displayed on the screen and is
available in all graph modes. In Profile and Power vs. Time modes, this
command will not work when trigger source is set to MANUAL. The
held graph can be requested over GPIB by using the OGD or OGBD
commands. The same graph data will be held until HOLD is switched
off.
Related
commands:
OGD, OGBD
Query: HOLD?
Returned String: HOLD <state>
polarity: POS (positive, for high TTL level)
NEG (negative, for low TTL level)
Remarks: Changes the expected polarity of the TTL Blanking input signal.
Query: IBBLP?
Returned String: IBBLP <polarity>
To Next Page
Loading...
